Clear Cord Clips for a New Desk Setup: Check the Surface First
A 13-clip pack for routing one cord at a time, with surface, fit and removal-space checks before you commit the adhesive.
The short answer
Command Clear Round Cord Clips suit a single-cord route along a compatible smooth wall or finished desk side. This guide covers CL017-13NA: 13 clear clips and 16 strips. The small clips keep the route simple, but surface preparation, cord fit and space to remove the adhesive matter more than the pack count. They are not cable-bundle holders or power-strip mounts.
The package’s “Damage-Free Hanging” wording is the brand’s claim, not our guarantee for your finish or rental deposit.
Check the surface first
The listing names smooth painted walls, finished wood, laminate, metal and tile. A desk still needs a compatible smooth finish; being furniture is not enough.
The official sheet specifies indoor use at 50–105°F. Do not use these clips on windows, wallpaper or textured surfaces, over beds, or for valuable or irreplaceable items or framed pictures. For fresh paint, follow both the paint’s requirements and the instructions in your supplied pack.
Check the cord, not just the clip dimensions
Try the round cord in an unattached clip without forcing it before using adhesive. The diagram gives approximate exterior dimensions: 1.25 inches high, 0.82 inches wide and 0.5 inch deep. None establishes a maximum cord diameter or load capacity.

Position the furniture first, then lay out the route. Leave room to reach every removal tab and stretch it along the surface. The maker illustrates one clip every 2 feet; that is routing guidance, not a load rating or an electrical-safety guarantee.

Install without skipping the wait

- Read the instructions in your pack. Clean the compatible surface with rubbing alcohol, not household cleaners.
- Remove the black liner. Apply the strip to the wall and press the entire strip firmly for 30 seconds.
- Remove the blue liner. Press the clip onto the strip firmly for another 30 seconds.
- Wait one hour before use. Keep the removal tab accessible when arranging the cord.
Leave room for removal
Hold the clip gently. Never pull the strip outward toward you. Slowly stretch it straight down against the wall for at least 6 inches, as the official sheet directs. If furniture prevents that movement, choose another location before installation.

The clip can be reused with Command Clear Small Refill Strips; the used adhesive strip cannot. Incorrect use can cause damage, and a suitable surface is still essential.
Choose this pack for a planned single-cord route, with time for installation and access for removal. Before buying, confirm the 13-clip, 16-strip CL017-13NA pack and check the current seller and delivery details on Amazon.
View the Command 13-clip pack on Amazon
Based on the corresponding Amazon listing and 3M’s 17017CLRES instructions. Manufacturer photos and diagrams are not our test results; we have not personally tested the clips.
Choose the item from this guide
